August 14, 2010
a simple engine ?
Do you think I could fit a Ram-Air 502ci Chevy crate engine in a 1994 Buick LeSabre?
Filed under Engines by on Aug 14th, 2010. Comment. 
Leave a Comment
Archives
- May 2012
- April 2012
- March 2012
- February 2012
- January 2012
- December 2011
- September 2011
- August 2011
- July 2011
- June 2011
- May 2011
- April 2011
- March 2011
- February 2011
- January 2011
- December 2010
- November 2010
- October 2010
- September 2010
- August 2010
- July 2010
- June 2010
- May 2010
- April 2010
- March 2010
- February 2010
- January 2010
Recent Posts
May 17, 2012
May 15, 2012
May 13, 2012
May 11, 2012
May 9, 2012
May 7, 2012
May 5, 2012
May 3, 2012
May 1, 2012
April 29, 2012
Copyright Big Block Chevy Engines, 2012
Comments on a simple engine ?
anything is possible, i have seen a 454 put into a Geo metro that ran low 8s in the quarter mile. probably the best thing to do would be to build a custom full frame because you would also have to change it to rwd. so you build a full frame including suspension, engine, trans, and rear end then just bolt the whole car to the frame. i would also suggest that if you were going through that much work, then you should also build a roll cage while your at it. i think it would be a waste of time but on the other hand, it would be an ultimate sleeper.
Virtually any engine swap is possible, the question is how much modification is neccesary to make the new engine fit not only physically, but how much modification is neccesary to make the car capable of handling the power of the larger engine, and in the case of your 94 LeSabre and your R-A 502c.i., you would practically have to build a custom frame in order to make the swap work, it’s just not a practical project car. Hope this helps.
George